Open the Alder app and log into your account.Ģ.

With Skybell's LEDs flashing Red/Green, follow these steps to sync it with your Alder Home Security account:ġ. The Red/Green flashing signal means the camera is now ready to sync to your Alder account! Once the backup battery is fully charged, LEDs will alternate between red and green. The Doorbell Camera will flash blue when the built-in backup battery is charging. With power restored, you should see the Doorbell Camera's LED illuminating. Use a small screwdriver (not a power tool) to tighten the set screw on the bottom of the Doorbell Camera body. Press the Doorbell Camera body over the mounting bracket until it's snugly in place. Attach the Doorbell Camera to the mounting bracket. Loosen the terminal screws and wrap the bare ends of the doorbell wires around the screw shafts below the heads. Connect power wires to the mounting bracket. Then, attach the bracket to the wall by driving the provided screws through the bracket's top and bottom holes. Attach Doorbell Camera mounting bracket.įeed the existing doorbell wires through the hole in the center of the Doorbell Camera mounting bracket. Carefully remove the existing doorbell button from its wall mounting.ĭisconnect the wires taking care not to let them slip down into the wall.Ģ. Remember to switch off your doorbell circuit breaker before installing your doorbell camera.ġ. Your browser does not support HTML5 video. The article will guide you through the mounting/installation of your doorbell camera.

Skybell hd won't sync